Serving Pretoria & JohannesburgMembrane waterproofing · Written quotes after a site visit

Guide · The Waterproof Company

Basement damp or a leak? When tanking is the right job

A wet basement, cellar or lower-ground room can have several causes, and they need different fixes. Before anyone quotes for basement tanking, it is worth working out whether water is actually coming in from the soil outside, or whether the problem is damp in the walls, condensation or a pipe. This guide explains the difference and when tanking is the right job.

Request a quote

Two different problems

Water coming in versus damp in the wall

Below ground, a wall or floor has soil against one side. After rain, that soil can hold water, and water in the ground pushes against the structure. If there is a crack, a poorly sealed joint or simply porous concrete or brickwork, water is driven through into the room. That is water ingress, and keeping it out is a waterproofing job.

Damp in masonry is different. Moisture moves slowly through brick and mortar, often without any visible water, and shows up as stains, flaking paint or salts. If the problem is in walls above ground level, such as rising or lateral damp, that is a damp-proofing job rather than tanking. Treating one problem with the other’s solution wastes money and usually does not work.

Signs that water is getting in from outside

  • Water on the floor, or a wet line along the wall-floor joint, after heavy rain.
  • Patches that get bigger after storms and dry back in the dry months.
  • Water seeping or running from cracks, construction joints or tie holes.
  • Wet areas that line up with a garden bed, a paving slope or a downpipe outside.
  • A room built into a bank, with the wet wall on the uphill side.

Note when the water appears, how long after rain, and where. Photographs taken during or soon after a storm are far more useful than a description later.

Rule these out first

Condensation, plumbing and surface water

Cool basements in a humid Gauteng summer can collect condensation, especially on walls and floors in contact with cold ground. A simple check is to tape a square of kitchen foil tightly to the wall for a day or two. If moisture forms on the room side of the foil, it is condensation; if it forms behind the foil, the moisture is coming through the wall. Ventilation, not tanking, solves condensation.

Leaking supply or waste pipes, a geyser overflow or a shower above can all look like ingress. If the water appears in dry weather, or does not change with rain, a plumber should check first.

Surface water is the other common contributor. Paving that falls towards the house, downpipes that discharge against the wall, or garden irrigation next to a basement wall all put more water into the soil exactly where you do not want it. Sorting those out is cheap and should happen alongside any waterproofing.

What tanking is

How tanking works

Tanking is a continuous waterproof barrier applied to the walls, and usually the floor, of a below-ground structure, so that it resists water under pressure from the soil. The word comes from the idea of making the room behave like a tank in reverse: water stays outside.

Several types of system are used. Cementitious tanking slurries are brushed or trowelled on in coats and bond to sound concrete and masonry. Bitumen-based and other liquid-applied membranes form a flexible layer. Sheet membranes are bonded or laid against the structure. Which is suitable depends on the surface, the water pressure and whether the barrier goes on the outside or the inside.

Outside face or inside face

The best place for a waterproof barrier is on the outside face, against the soil, because water pressure then pushes the membrane onto the wall rather than off it. This is called the positive side. It is straightforward when a basement is being built, but on an existing building it means excavating along the wall, which is not always possible next to a boundary, a driveway or another structure.

When the outside cannot be reached, the barrier goes on the inside face, the negative side. Systems designed for this, usually cementitious, bond into the structure and resist pressure from behind. Preparation matters even more here: the surface must be sound and clean, with active leaks stopped and cracks repaired before the system goes on. Anything fixed to the wall afterwards, such as shelving or skirting, must not puncture the barrier, so services and fixings need planning.

Local conditions

Gauteng ground and summer storms

Parts of Pretoria and Johannesburg have clay-rich soils that hold water and swell when wet, then shrink in the dry winter. Sloping plots often have rooms cut into the hillside, with soil against one or more walls. In the summer storm season, a large amount of rain can arrive in a short time, and the soil around a basement can become saturated quickly. A basement that is dry for most of the year may only show the problem from about November to March.

That seasonal pattern is useful evidence. If you can show that the water appears after storms and dries back over winter, it points strongly to ingress from outside rather than condensation or plumbing.

Deciding

When tanking is, and is not, the right job

Tanking is usually the right approach when:

  • water is clearly coming through below-ground walls or floors from the soil side;
  • the room is to be used as living or storage space and needs to stay dry; and
  • the structure itself is sound, or can be repaired first.

It is usually not the answer when the moisture is condensation, a plumbing leak, or damp in walls above ground level, or when the real fault is surface water that better falls and downpipe outlets would solve. Where large amounts of ground water are involved, drainage around the building may also need advice from a drainage contractor or engineer, and tanking works best as part of that plan.

Comparing quotes

What an inspection and quote should cover

An inspection should look at where and when the water appears, the condition of the walls and floor, what is outside the wall, and whether the outside can be reached. The written quote should then say which face the system goes on, the product and number of coats, how cracks, joints and active leaks will be treated first, how the wall-floor junction is detailed, what happens to existing finishes and fixings, and what is excluded.

Be wary of any quote that proposes a waterproofing paint on the inside of a basement wall without explaining how it will resist water pressure from behind. A finish that is not designed for that tends to blister and peel when the next storm arrives.

Written by The Waterproof Company.

Next steps

Read more about basement waterproofing and tanking, or about conditions on clay and sloping plots on our waterproofing in Pretoria page. When you are ready, request a quote.

Request a waterproofing quote

Send your suburb, what is leaking and a few photos. We arrange a site visit and set out the work in a written quote.

Request a quote