Serving Pretoria & JohannesburgMembrane waterproofing · Written quotes after a site visit

Roof waterproofing in Pretoria and Johannesburg

Roof waterproofing means adding a membrane or liquid system to a roof that is otherwise staying in place. The Waterproof Company works mainly on flat and concrete slabs, and on metal or tiled roofs that are sound but letting water through at joints and details. We visit first, then set out the system and the details in a written quote.

Request a quote

When a roof needs a membrane

Concrete slabs and flat roofs rely completely on their waterproofing layer. When that layer cracks, blisters, loses its reflective coat or lifts at the edges, water finds its way into the slab and shows as a stain on the ceiling below. Water that stands for days after a storm is another sign: ponding speeds up wear and pushes water into every weak lap.

A sound metal or tiled roof can also benefit from a liquid system at laps, fixings and junctions where water keeps getting through. In each case the roof itself stays; the waterproofing is what changes.

If tiles are broken or the sheeting is rusted through and needs replacing, that is a roofing job rather than a waterproofing one, for The Roofing Company Pretoria or The Roofing Company Johannesburg, depending on the city. We will tell you if that is what we find.

Flat and concrete roofs

Flat concrete roofs, parapet roofs and slabs over garages and extensions are a common type of enquiry. The usual choice is between a heat-bonded torch-on membrane and a liquid rubber system, chosen for the surface, the details and how the roof is used.

Before any product goes down, the falls and outlets have to work. Our flat roof waterproofing page explains ponding, outlets, box-gutter linings and upstands in more detail.

Metal, IBR and tiled roofs that are otherwise sound

On IBR, Chromadek and corrugated roofs, water often gets in at side and end laps, around fixings and at penetrations such as vent pipes and solar mounts. Where the sheeting is sound, a liquid-applied system with reinforcement at those points can seal them without the heat of a torch.

On tiled roofs we look at junctions, valleys and abutments where a waterproofing detail can be added or renewed. Re-sheeting a roof or replacing tiles is not part of this service.

Details that decide whether the system holds

Most roof waterproofing failures start at a detail, not in the middle of the roof. The details we check and price for are:

  • Outlets: set at the right level, large enough and properly lapped into the membrane.
  • Upstands: the membrane turned up walls and parapets far enough, and sealed at the top.
  • Penetrations: pipes, geyser supports, air-conditioning brackets and solar mounts.
  • Parapets and copings: cracks on top of the wall let water in behind the system.
  • Laps and joints: overlaps that are wide enough and fully bonded.

What the written quote should include

A clear roof waterproofing quote lets you compare contractors on the same basis. It should name the system and product, the area in square metres, the preparation (cleaning, removing loose material, priming, repairs to the substrate), how many layers or coats, how outlets, upstands and penetrations are finished, and any reflective topcoat that forms part of the system.

It should also say what is excluded and whether any guarantee applies, with its terms in writing. We do not publish prices without seeing the roof, because size, access and condition change the job.

Common questions

Can you waterproof a roof that is leaking now?

Yes, but most systems need a dry surface to bond. During the summer rains we plan work around the forecast, and a temporary measure may be needed until a dry window allows the permanent system to go down.

Do you replace broken tiles or roof sheets?

No. Replacing tiles or sheeting is roofing work. If we find a failed covering, we will say so. Our work is the membrane or liquid system on a roof that is staying in place.

Should I choose torch-on or a liquid system?

It depends on the surface and the details. Torch-on suits many concrete slabs; liquid systems suit metal roofs, awkward shapes and places where a flame is unsafe. Our guide on torch-on or liquid rubber explains the trade-offs.

Can solar panels stay on the roof?

Often, yes. Mounts and cable entries are penetrations that need careful detailing. Tell us about panels or geysers on the roof when you enquire, as access and any temporary removal affect the plan.

Is the reflective coat just paint?

No. A reflective topcoat on a membrane protects it from UV and heat as part of the waterproofing system. It is not a decorative roof paint, and the quote should name it as part of the system.

Related waterproofing services

Torch-on waterproofing

Heat-bonded bitumen membranes for slabs, parapets and box gutters, laid with sound laps and upstands.

Torch-on waterproofing →

Liquid rubber waterproofing

Seamless liquid-applied systems for metal roofs, awkward details and places where a flame is not suitable.

Liquid rubber waterproofing →

Roof waterproofing in Pretoria and Johannesburg

We carry out roof waterproofing for homes, complexes and business premises across both cities. See waterproofing in Pretoria and waterproofing in Johannesburg for local conditions, or check the service areas page for suburbs.

To get started, request a quote with your suburb, a short description and a few photos. We arrange a site visit and send a written scope before any work is agreed.

Request a waterproofing quote

Send your suburb, what is leaking and a few photos. We arrange a site visit and set out the work in a written quote.

Request a quote